![]() ![]() (7) Advanced: Adjust brightness, contrast, sharpness, etc. (6) Privacy Mask: Set to block out specific areas. (5) Anti-flicker: If the image of the camera is exposed, you can try to adjust this setting. (4) Watermark: Enable/Disable Reolink watermark. (3) Date & Time: Choose where the date & time is displayed. Here is a video of enabling/disabling Add Device Automatically via Reolink Client. (2) Camera Name: Choose where the camera name is displayed. Applies to: All Reolink cameras and NVRs. displaynewclient1.png (1) Flip/Mirroring: Change the direction of the image. It's also related to the installation of your camera. Launch camera on the client and go to Settings > Camera > Display page. (1) Flip/Mirroring: Change the direction of the image by enabling or disabling these options. Wanna go a step furtherput them all in a separate VLAN and selectively allow access via certain devices (NVR, your phone, etc) and only when that device initiated the connection. On the display settings page, you can change the settings below: Launch camera on the client and go to Settings > Camera > Display page. For example, change the camera's name position, date and time position, hide the watermark, etc. For instance, in level 1, the alert will be triggered when motion is. The higher the level, the more sensitive the motion detection. ![]() You may drag the slider to the left (right) side to set the motion detection sensitivity.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |